30012 Test Pattern Generator TPG: timed out waiting for stripe to complete All The test pattern generator (TPG) on the DPE is not functioning properly. The TPG is used at the beginning and end of every image to setup and shutdown the data buffers. If this error occurs at the beginning of an image, the DPE should be re-seated and all power supply levels (including the -5.2V and +4.6V ECL supplies) should be checked using the test points on board. If the problem does not go away, the DPE should be replaced. If this error occurs at the end of an image, the DPE should be checked. However, the error may be due to a firmware bug in the image shutdown routine, and the responsible firmware programmer should be contacted. Record error message and contact Creo service Out of spec. power supply levels Faulty DPE If at the end of an image, possibly due to a firmware bug. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:16 2008 PST